
Overview
Rochester Manufacturing Group runs two metal stamping shops in the Rochester area: Rochester Stampings in Rochester and Stever Locke in Honeoye Falls. Between them they cover progressive, compound, blanking, and form die work, from short runs up to 7,000 parts per hour.
Stever Locke specializes in electrical terminals and connectors held to ±.0005" and in stamping non-metals like mica and Nomex. Rochester Stampings makes special flat washers and adds fabrication and machining, so a stamped part can leave finished.
What we offer
Progressive & compound dies
Progressive, compound, blanking, and form dies, from short runs to 7,000 parts per hour.
Electrical terminals & connectors→
Niche terminal and connector stampings holding ±.0005" tolerances.
Washers 1" O.D. and under in thousands of thickness and shape combinations.
Mica, Nomex, Mylar, Lexan, insulation board, and laminates.
In-house die shop
Die design, building, and maintenance under the same roof as the presses.
Secondary operations
Deburring, grinding, assembly, and kitting after the press.
Where it's made
Two RMG shops that do it
Questions
Metal Stamping FAQ
Do you take short-run metal stamping jobs?
Yes. Both RMG stamping shops run short and long jobs, from small lots up to 7,000 parts per hour on high-volume work.
Can you stamp materials other than metal?
Yes. Stever Locke in Honeoye Falls stamps mica, Nomex, Mylar, Lexan, insulation board, and laminates, and Rochester Stampings stamps plastics and rubbers like acetal, phenolics, UHMW polyethylene, Viton, and neoprene.
Where are your metal stamping shops?
Rochester Stampings is at 400 Trade Court in Rochester, NY, and Stever Locke is at 179 N Main St in Honeoye Falls, NY.
Need metal stamping in Rochester?
Tell us about your part. We'll route it to the right RMG shop and get back to you with a quote.